Wet Bar Lighting

Wet Bar Lighting | One of the main reasons people choose LED rope lighting over other kinds of lighting is since it is so versatile. Not only can you choose shaped to match any area, it is usually cut to match and spliced to pieces in case a longer piece is necessary.

It can even be sliced if you prefer a color combination to match your d?Ă½cor. It is important to know precisely your work before you start cutting the rope or make an effort to splice it. The following is helpful information for cutting and splicing LED rope lighting:

• Cutting the Rope Lights – In order to chop these lights you must have one of many following, a PVC pipe cutter, box cutter or heavy-duty scissors. It is advisable to possess the pipe cutter since you get yourself a straighter edge and there’s less probability of cutting crooked. The entire pipe has slash marks around the pipe to inform you where it is usually cut. Do not cut anywhere which is not marked or you’ll wind up ruining that piece of light so that it is useless. These slash marks run from either eighteen inches or thirty-six inches.

See also: Weisslicht Led Fog Light Bulbs

The two wire type is every eighteen inches and the three wire, or chaser lights, is every thirty-six inches. You should look at the area you want to cover carefully and choose the rope type based on how much time the rope should be. If thirty-six inches is way too long you’ll need to obtain the two-wire light. Make the cut cleanly after which trim off the excess copper wire from the end by bending the sunshine to reveal it. Once it really is properly prepared, you’ll want to add the connector kit or splice another color or length to the sunshine.