Small Church Stage Lighting

Small Church Stage Lighting | One of the main reasons people choose LED rope lighting over other forms of lighting is since it is so versatile. Not only can it be shaped to suit any area, it may be cut to suit and spliced with other pieces if your longer piece should be used.

It can also be sliced if you prefer a color combination to match your d?Ă½cor. It is important to know precisely your work before you start cutting the rope or make an effort to splice it. The following is a guide for cutting and splicing LED rope lighting:

• Cutting the Rope Lights – In order to chop these lights you must have one of the following, a PVC pipe cutter, box cutter or heavy-duty scissors. It is advisable to hold the pipe cutter as you obtain a straighter edge and there is less possibility of cutting crooked. The entire pipe has slash marks about the pipe tell you where it may be cut. Do not cut anywhere which is not marked or you will end up ruining that part of light so that it is useless. These slash marks run from either eighteen inches or thirty-six inches.

See also: Progress Lighting Semi Flush Mount

The two wire type is every eighteen inches as well as the three wire, or chaser lights, is every thirty-six inches. You should look at the area you want to cover carefully and select the rope type based on the length of time the rope should be. If thirty-six inches is just too long you’ll need to get the two-wire light. Make the cut cleanly and then trim off the excess copper wire from your end by bending the sunshine to reveal it. Once it can be properly prepared, you’ll want to add the connector kit or splice another color or length to the sunshine.