Saber Ii Led Light

Saber Ii Led Light | One of the main reasons people choose LED rope lighting over other forms of lighting is because it is so versatile. Not only can or not it’s shaped to match any area, it can be cut to match and spliced with other pieces if the longer piece should be used.

It can also be sliced if you prefer a color combination to match your d?Ă½cor. It is important to understand specifically your work before you start cutting the rope or attempt to splice it. The following is helpful tips for cutting and splicing LED rope lighting:

• Cutting the Rope Lights – In order to reduce these lights you must have one of several following, a PVC pipe cutter, box cutter or heavy-duty scissors. It is advisable to possess the pipe cutter since you get a straighter edge and there is less possibility of cutting crooked. The entire pipe has slash marks around the pipe to show you where it can be cut. Do not cut anywhere that isn’t marked or else you will turn out ruining that little bit of light making this useless. These slash marks run from either eighteen inches or thirty-six inches.

See also: Vintage Bathroom Lighting Fixtures

The two wire type is every eighteen inches and also the three wire, or chaser lights, is every thirty-six inches. You should look at the area you would like to cover carefully and select the rope type based on how much time the rope needs to be. If thirty-six inches is too long you’ll need to get the two-wire light. Make the cut cleanly after which trim from the excess copper wire from your end by bending the lighting to reveal it. Once it is properly prepared, you need to add the connector kit or splice another color or length to the lighting.