Bar Lighting Ideas

Bar Lighting Ideas | One of the main reasons people choose LED rope lighting over other kinds of lighting is because it’s so versatile. Not only can it’s shaped to match any area, it is usually cut to match and spliced along with other pieces if the longer piece should be used.

It may also be sliced if you prefer a color combination to match your d?Ă½cor. It is important to specifically what you’re doing before you begin cutting the rope or try to splice it. The following is helpful information for cutting and splicing LED rope lighting:

• Cutting the Rope Lights – In order to slice these lights you need to have one of many following, a PVC pipe cutter, box cutter or heavy-duty scissors. It is advisable to hold the pipe cutter as you have a straighter edge as there are less potential for cutting crooked. The entire pipe has slash marks for the pipe to show you where it is usually cut. Do not cut anywhere that is not marked or you will end up ruining that bit of light making this useless. These slash marks run from either eighteen inches or thirty-six inches.

See also: Patriot Lighting Instructions

The two wire type is every eighteen inches along with the three wire, or chaser lights, is every thirty-six inches. You should look at the area you want to cover carefully and choose the rope type in accordance with how long the rope has to be. If thirty-six inches is just too long you will need to get the two-wire light. Make the cut cleanly and after that trim off of the excess copper wire through the end by bending the sunshine to reveal it. Once it is properly prepared, you have to add the connector kit or splice another color or length to the sunshine.

Tags: